What are the types of vectors? their possible breeding sites and how to control them?

Thousands of animals can be vectors. Some of the most common ones are ticks and mosquitoes. Ticks breed almost anywhere. Mosquitoes need swamps, puddles, marshes ect. Ticks are very hard to control, but mosquitoes can be controled y draining bodies of water. This of course brings harmful effects to many types animals.

Chemical control of vectors?

chemical control of vectors is killing rodents and pests using poison and insecticide in the wild. When a city is notified of an increased rat population chemical control vector stabilizing agencies are dispatched (aka exterminators) and they set poison in the fields and kill the pests).Chemical control of vectors?
Thats just bogus..I would flunk(well maybe a ';b';) science even if I could have an ';A';...shame ,shame but been there done that.....I just insist on being ignorant..For which I


know I am not being....I do'nt believe there is many


if you are messing with human dna...Splicing genes is just


a nono in my conscience...They will never succeed without


unknown harm and injury and could never truly ';control';The out comes..Or would,take responsibility ..for that matter..

Torque ratings of 3 phase 480 volt ac motors controlled by vector vfd ?

A vector or even a sensorless vector VFD should be capable of operating a motor from base speed right down to or very nearly to zero speed at 150% of rated torque as calculated from the nameplate speed and power ratings. The current required to produce 150% of rated torque should not exceed 150% of the motor nameplate current. The minimum speed at which the motor can produce rated torque continuously and the maximum time that rated torque can be maintained at stall depends on the specific motor design, particularly the cooling provisions. Motors equipped with a separately powered cooling fan can typically sustain rated torque at zero speed continuously. Manufacturers of VFD rated motors usually have rating curves that show the motor torque vs. speed continuous and intermittent capability.

How do I get air traffic control to give me vectors to the runways? (FSX)?

Hey guys, I play FSX and im having trouble getting ATC to give me vectors for the runway.





How do I get ATC to give me vectors to the runway?





i.e. In the mission Monsoon approach they give me the heading and altitude to line me up with the runway, then they hand me off to the tower, and they'll give me clearance to land and confirm that I have the runway in sight.





Thankyou in advance.





-Con.How do I get air traffic control to give me vectors to the runways? (FSX)?
In the military, you would say ';Approach, %26lt;state your call sign%26gt; request vectors to %26lt;type of approach%26gt;,'; for an IFR approach. If you were VFR, you would simply request the straight-in/overhead/whatever.





In a flight sim, unfortunately, i do not know. But you may want to check and make sure you're expected to shoot an IFR approach. VFR, the radar controllers will not give you hard vectors, only suggestions, particularly if you're below MVA.